Especially for the inside !!

Finally a foil that no longer poses any danger to the efficiency glass.
For a long time, sticking foil on the inside of Rendementsglas was strictly prohibited.

There was a high probability that due to the strong heating of the glass plate on the inside, the
glass plate would crack and cause a thermal break.

That is about to change !!

Experience the advantage of sticking on the inside of the efficiency glass no need for high scaffolding
or arial work platforms.
No more problems with too low a temperature to stick the film, no more problems with wind and sand
that irrevocably hinder and disrupt your work.

The amount of heat rejection is shown below in the picture.

 NOTE NOW ALSO AVAILABLE ON ROLL WIDTH 182 CM Price on request.

How is that possible?

Thanks to the very latest techniques, a foil has been developed that reflects the solar heat,
but does not retain it and therefore builds up less heat.

The foil becomes slightly warmer than the glass, but it no longer poses any danger to your window.
A solution for places that are difficult to reach from the outside and… can be used all year round.

What is important is that the foil is not covered with curtains, blinds or net curtains, the space behind the
window must remain free.
Part of the heat passes through the foil and must not be hindered

from flowing through.

When you order the Starlett 40, please state the code of your glass in the 'comments' in the shopping
cart, which can be found in the silver border between the two glass plates.
We can then assess whether this is the right foil.